PT. MIMAKI INDONESIA

Even after maintenance, issues such as nozzle dropout and deflection remain unresolved.

  • If foreign objects on the nozzle surface are the cause, powerful maintenance with Maintenance Liquid 16 may resolve firing issues.

[Important]
When performing powerful maintenance using Maintenance Liquid 16 for the first time, 
please consult our engineers for the procedure in advance.

* The powerful maintenance may not resolve all firing issues.
   Firing issues caused by factors other than foreign objects on the nozzle surface may not be resolved.

[Precautions]
Please be sure to confirm in advance.


How to perform powerful maintenance
<Step 1>
Use Maintenance Liquid 16 to perform nozzle wash.
(1) On the LOCAL mode screen, select  [FUNC1] (MEMU) > [MAINTENANCE]
  > [Station] > [Nozzle Wash].
(2) Clean the wiper and the bracket using the maintenance liquid for daily maintenance
     (Maintenance Liquid 16 cannot be used)
 and press the [ENTER] key.
(3) Clean around the caps using the maintenance liquid for daily maintenance
     (Maintenance Liquid 16 cannot be used)
 and press the [ENTER] key.
(4) Fill the cap of the area where the issue is occurring with Maintenance Liquid 16.
- Amount to use: Fill the cap until it's full (approx. 3 cc, equivalent to 1.5 syringe doses).
- Be careful not to spill the Maintenance liquid 16 from the cap.


(5) Press Up/Down key to set the waiting time to 10 minutes, then press the [ENTER] key.
- If you cannot set the waiting time on your product, please contact our call center for a version
upgrade that requires an on-site visit.
After nozzle cleaning is completed, please proceed to the next step 2 immediately without delay.


<Step 2>
Promptly perform head cleaning (Hard).
Please refer to the "Operation Manual" for the head cleaning procedures.


<Step 3>
Perform a test print to confirm if the firing issue has been resolved and if there are any
abnormalities in the color of the print result.
■ If the firing issue does not recover:
Return to Step 1 and perform wiper rubber cleaning, cap rubber cleaning, and nozzle wash again.
If there is no improvement even after performing it three times, please contact our call center.

■ If firing issues have been resolved but there is an issue with color
(such as being too light or mixed colors):

Please execute [DISWAY WASH] and perform wiper cleaning using the maintenance liquid for daily maintenance (not suitable for Maintenance Liquid 16).
If no improvement is observed, please contact our call center.

■ If recovery is successful and there are no color issues:
Powerful maintenance is complete.



Please refer to this video for reference.
Types and selection of maintenance liquid for UV ink






Return to Content

PAGETOP